Our experts inspect your overall blasting process, implement the correct air separator settings and any necessary hot spot adjustment to minimize wear and reduce your operation costs.
Blast Pattern Controls / Hot Spot Adjustment / Amp Efficiency Checks / Flow Optimization
Do you know the consequences of improper hot-spot setting?
Extra wear on blasting room shieldings and blasting wheel housing
20% of the hot-spot area located on shieldings cause:
+10% abrasive consumption
Blast Wheels / Air Separator Control & Adjustment / Material Handling system / Abrasive Reclaim System
/ Operating Mix Analysis / Waste Analysis
Do you know that poor air separator setting is one of the main causes of wear?
- Too fine O.M.
- Extra-wear on wheel blades
- Too coarse O.M.
- Low coverage higher blasting time extra-wear
- Dust or sand in O.M.
- Heavy extra-wear
Sand content of the operating mix has a major influence on blades lifetime.
Roughness Check with perthometer / Roughness Check 3D / Visual Cleanliness Result Evaluation
/ WA Clean cleanliness evaluation / Dust Analysis with Dust Kit Test / Coverage Rate
Strong through our wealth of experience, our engineers have developped exclusive technologies which will allow you to analyze your blasting performance. Each blasting issue has its own technology :
This patented and ISO certified technology is used to check the cleanliness of a blasted base material in accordance with international standards, independently of any human interpretation.
This allow you to visualise the roughness profile of a blasted surface in the form of a 3D representation.
10% AVERAGE OF REDUCTIONon your blasting cost operation.
3 000 CUSTOMERShave already optimized their costs.
10 000 COMPANIESfrom around the world work with W Abrasives.